Ambient Light Control (Optional) - JVC CO-46LCD-BD Bedienhandbuch

Ambient Light Control (optional)

ENGLISH
Downloaded from www.Manualslib.com manuals search engine
2 - middle intensity
3 - high-level intensity
S Off
The"Dynamic pixel refreshing" is switched off.
Soft picture mode
The function draws the picture artificially unsharp
through which the edges are less sharp.
Choose one of the following options with the button
[ ] / [
A "
S
1, 2 or 3
You can increase or decrease the unsharpness of
the picture with these values.
1 is the lowest unsharpness and 3 is the highest
unsharpness
S Off
The "Soft picture mode" is switched off.
S To close the menu press the red button.
A light sensor installed in display panel is used to
sense the ambient light level. The range of ambient
light depends on the installation site and can vary in
public travel applications between 100 Lux and 1000
Lux. Higher ambient light levels near the panel surface
decrease the contrast ratio and result in a low legibility
of the presented information. Through a bright envi-
ronment the intensity performs apparently in a smaller
way.
The brightness values measured by the light sensor
are compared with preset reference values. The result
evaluates and used for the automatic adjustment of
the display brightness.
If the brightness of the environment sinks, the display
brightness is decreased. If the brightness of the envi-
ronment rises, the display brightness is increased.
This control provides best legibility under varying am-
bient light levels and extends the life time of the dis-
ALC sensor
play.
Adjust Backlight ALC
This function regulates the backlight brightness into
dependence of the ambient light. To avoid the image
flicker, a change lasts approx. 3 min from minimum to
maximum and in reverse order.
The backlight brightness changes with the ambient
light synchronous.
S
Press the [MENU] button to open the main menu.
S With the button [
menu.
S Choose with the buttons[
<Backlight ALC>.
You can set this option to on or off with the buttons
[ ] / [
A
] :
] or [ ] select the <Picture>
A "
] / [ ] the menu item
Y B
].
"
31