Setting The Delay Time - Denon AVR-1602 Bedienungsanleitung

ENGLISH

Setting the delay time

Input the distances from the listening position to the speakers and set the surround
delay time.
Preparations:
Measure the distances from the listening position to the speakers (L
diagram at the right).
L : Distance from center speaker to listening position
1
L : Distance from front speakers to listening position
2
L : Distance from surround speaker to listening position
3
CAUTION:
Set the center speaker at the same distance from the front speakers (left and right) or the subwoofer, or so
that the difference in distance (L
2
Set the surround speakers (left and right) at the same distance from the front speakers (left and right) or the
subwoofer, or so that the difference in distance (L
1
Use the
speakers and subwoofer to the listening position.
• The number changes in units of 0.1 meter each time one of the buttons is
pressed. Select the value closest to the measured distance.
("/SW" appears only when subwoofer = yes.)
Press the SELECT or
NOTE:
• The speaker distance can be adjusted between 0 and 18 meters in steps of 0.1 meter.
2
Use the
speakers to the listening position.
• The number changes in units of 0.1 meter each time one of the buttons is
pressed. Select the value closest to the measured distance.
Press the SELECT or
NOTE:
• No setting when "None" has been selected for the center speaker.
3
Use the
speakers to the listening position.
• The number changes in units of 0.1 meter each time one of the buttons is
pressed. Select the value closest to the measured distance.
Press the SELECT or
DIGITAL input (COAX) setting.
NOTE:
• No setting when "None" has been selected for the surround speakers.
10
Downloaded from www.Manualslib.com
to L on the
1 3
– L ) is 1.5 meters or less.
1
– L ) is 4.5 meters or less.
2 3
(left) and (right) buttons to set the distance from the front
6 FRNT/SW 3.6m
(down) button to switch to the center speaker setting.
(left) and (right) buttons to set the distance from the center
7 CENTER 3.6m
(down) button to switch to the surround speaker setting.
(left) and (right) buttons to set the distance from the surround
8 SURR. 3.0m
(down) button to enter the setting and switch the
manuals search engine
Digital input setup
Input the type of components connected to the digital input terminals.
FL Center FR
1
L
1 Listening
L
2
position
L
3
9 COAX
SL SR
2
10 OPT
NOTE:
• TUNER cannot be selected.
After setting up the system
1
This completes the system setup operations. Once the system is set up, there is no need to make the settings
again unless other components or speakers are connected to or the speaker layout is changed.
Use the (left) and (right) buttons to set the type of device connected
to the COAXIAL input (COAXIAL) terminal.
(Initial)
CD DVD TV VCR
DVD
(left) button
• Select "OFF" if nothing is connected.
Press the SELECT or (down) button to switch the optical input (OPT) setting.
Use the (left) and (right) buttons to set the type of device connected
to the OPTICAL input (OPTICAL) terminal.
(Initial)
CD DVD TV VCR
TV
(left) button
• Select "OFF" if nothing is connected.
Press the SELECT or (down) button if you want to start the settings over
from the beginning.
Press the SYSTEM button to finish system set up.
V.AUX CDR OFF
(right) button
V.AUX CDR OFF
(right) button