Setting The Digital In Assignment; Setting The Auto Surround Mode - Denon AVR-1603 Bedienungsanleitung

ENGLISH

Setting the Digital In Assignment

Input the type of components connected to the digital input terminals.
1
Use the
to the COAXIAL input (COAXIAL) terminal.
10 COAX CD
• Select "OFF" if nothing is connected.
Press the ENTER or
setting.
2
Use the
to the OPTICAL input 1 (OPT 1) terminal.
11 OPT1 DVD
• Select "OFF" if nothing is connected.
Press the ENTER or
setting.
3
Use the
to the OPTICAL input 2 (OPT 2) terminal.
12 OPT2 TV
• Select "OFF" if nothing is connected.
Press the ENTER or
setting.
NOTE:
• TUNER and V. AUX cannot be selected.
12
(left) and (right) buttons to assign the input function connected
(Initial)
CD AUX DVD TV VCR
(left) button (right) button
(down) button to switch the optical input 1 (OPT 1)
(left) and (right) buttons to assign the input function connected
(Initial)
CD AUX DVD TV VCR
(left) button (right) button
(down) button to switch the OPTICAL input 2 (OPT 2)
(left) and (right) buttons to assign the input function connected
(Initial)
CD AUX DVD TV VCR
(left) button (right) button
(down) button to switch the auto surround mode

Setting the Auto Surround Mode

For the three kinds of input signals as shown below, the surround mode played the last is stored in the
memory. At next time it the same signal inputs, the memorized surround mode is automatically selected and
the signal is played.
Note that the surround mode setting is also stored separately for the different input function.
SIGNAL
q
Analog and PCM 2-channel signals
CDR OFF
w
2-channel signals of Dolby Digital, DTS or other multichannel format
e
Multichannel signals of Dolby Digital, DTS or other multichannel format
1
CDR OFF
Setting the Ext. In SW Level
Set the method of playback of the analog input signal connected to the Ext. In terminal.
1
CDR OFF
After setting up the system
1
This completes the system setup operations. Once the system is set up, there is no need to make the settings
again unless other components or speakers are connected to or the speaker layout is changed.
Use the (left) and (right) buttons to select the Auto Surround mode.
OFF
13 AUTOSURR. ON
(left) button
Press the ENTER or (down) button to switch the Ext. In SW Level setting.
Use the (left) and (right) buttons to select the Ext. In Subwoofer channel
Level playback.
+00
14 EXT.IN SW +15
(left) button
Press the ENTER or (down) button if you want to start the settings over
from the beginning.
Press the SYSTEM SETUP button to finish system set up.
Default Auto Surround Mode
STEREO
Dolby PLII Cinema
Dolby or DTS Surround
(Initial)
ON
(right) button
(Initial)
+05 +10 +15
(right) button