Operation Crmx - Litecraft CubeX.4 Bedienungsanleitung

Operation CRMX

The unit is equipped with an integrated LumenRadio CRMX-mo-
dule. The module is compatible to CRMX transmitter units from
LumenRadio and Wireless Solutions transmitter units version G3
and G4.
For the use with CRMX the unit needs to be set to one of the five
DMX-modes. Press MODE button and use UP/DOWN buttons un-
til display shows „PErS". Press ENTER and choose the right mode
by use of UP/DOWN buttons. Furthermore you need to choose
the corresponding DMX-start adress. Which mode is the right
one for you is up to the range of functions you would like to use,
the library and the channels of the used DMX-controller. Please
read chapter DMX-Mode of this manual to get an idea of which
channels can be controlled in which DMX-mode.
Up next there is a need for logical connection (pairing) of the
unit with external DMX-transmitter. Press CONNECT button on
DMX-transmitter shortly. The transmitter searches for all availa-
ble units and connects to them. The logical connection (pairing)
is done and safed until it is released manually.
NOTE!
If a unit is not connecting to an external DMX-transmitter it is
already connected logical to another transmitter. In this case the
connection needs to be released manually. Press and hold CON-
NECT button on corresponding CubeX.4 for at least 3 seconds.
After this please repeat the procedure for logical connection
(pairing) whilst pressing CONNECT button on DMX-transmitter
shortly again.
21