Designated Use; Installation - Litecraft CubeX.4 Bedienungsanleitung

Designated Use

This product is a spotlight, which is designed only for professi-
onal use on stages, discotheques, theatres, etc. This product is
approved for mains connection up to 230 volts and designed for
indoor use.
• Please avoid any kind of shocks and outer actions during its
installation or transportation.
• Take care of too high ambient temperature, humidity and dust
when choosing the installation location. Assure that all cables
are fixed. Incorrect operation may lead to danger.
• Image shows the minimum distance to illuminated ob-
jects. Minimum distance between fixture and illuminated sur-
face is 0,1 meters
• Assure that the area below the mounting position of the fix-
ture is roped in while mounting, dismantling and service.
• The spotlight itself and its accessories like color frame and bar-
ndoors have to be safed with a suitable safety chain.
• Assure that the maximum ambient temperature is never excee-
ded.
• Do not put the fixture in operation before you are familiar
with its functions. Keep the product away from children and
unskilled people.

Installation

• There are specific regulations like BGV C1 (old VBG 70) or
country related regulations which need to attend during
the installation. The installation has to be handled by skilled
persons only!
• Suspension device hast to be built and calculated in order to
handle up to 10 times its specific load limit over a time of one
hour without permanent or harmful deformation.
• Installation has to be done with a separate, independent sus-
pension device like a safety chain. A second suspension device
has to be built in order to assure that in case of error no part
of an installation can fall off.
• Trepassing the danger zone below the installation during the
assembling is prohibited.
• Installer has to take care of all safety and machinery installati-
ons are approved by authorized persons before first operati-
on or after changes before restarting.
• Installer has to take care of all safety and machinery installati-
ons are approved by skilled persons at least once a year.
• Installer has to take care of all safety and machinery installa-
tions are approved by authorized persons at least every four
years during the acceptance inspection.
• Spotlight should ideally installed outside peoples lounge area.
ATTENTION!
Installation overhead needs a high level of experience. This in-
cludes (but is not just limited to) calculation and definition of
load capacity, used installation material and regular safety ins-
pections of used material and the fixture itself. Never try to do
the installation by yourself if you are not qualified, instead you
18
have to instruct a skilled installer. Inappropriate installations can
cause injuries and/or damage of property.
• Spotlight has to be installed outside areas where people can
touch it.
• Professional truss system or similar licensed suspension systems
have to be used if the spotlight is used in suspension from cei-
ling or other constructions. Spotlights can never be installed
freely suspended!
ATTENTION!
Spotlights can cause injuries when fall off. If you are not trained
in questions of safety for the different kinds of installation do
NOT install the spotlight!
• Assure that the mounting surface can hold at least ten times
the point load of the spotlight before installing the fixture.
ATTENTION!
Assure the specified safety distances to flammable material.
• Attach the spotlight with its yoke and the use of a suitable
hook/clamp to your truss system. According to your installati-
on also similar but approved suspension devices are possible.
The therefor used opening has a diameter of about 10 mm.
• When installing the spotlight overhead make sure to safe the
fixture by a safety chain which is specified at least with a load
limit of 12 times of the spotlights weight. Only safety chain
with approved connective can be used. Attach the safety
chain to its designated opening and attach it to the truss
system or a similar and safe attachment point. Assure to close
the fasteners as specified.
• To adjust the angle of the fixture open the locking screw, set
the fixure in its position and close it by hand.