Connecting The Gas Cylinder To The Appliance - Klarstein Valkyrie Bedienungsanleitung

EN
16
Special notes
• If you have any questions concerning assembly or operation, consult your dealer or
LPG Gas Company.
• When in use place the appliance and cylinder on a flat level surface.
• Never light the grill or rear burners with the hood in the closed position.
• Never light the side burner with the lid in the closed position.
CONNECTING THE GAS CYLINDER TO THE
APPLIANCE
Note: The appliance must be equipped with an EN 16129-approved gas regulator
and EN 16436-1-approved gas hose with a minimum length of one metre. If not
included in the delivery, they must be purchased additionally.
• Your barbecue can be used with gas cylinders between 1 1 kg and 15 kg. The
maximum size of the gas cylinder should be: Ø 32 cm and the maximum height
60 cm. Follow the technical information as stated in the instruction manual and
Check with your local gas supplier to have a suitable gas cylinder for your
barbecue.
• A pan with a diameter of Ø 12-22 cm can be placed on the hot plate of the side
burner.
• This appliance is only suitable for use with low-pressure butane or propane gas or
LPG mixtures, fitted with the appropriate low-pressure regulator via a flexible hose.
• The hose should be secured to the regulator and the appliance with hose clips.
Make sure the flexible hose could not come in contact with hot surface and avoid
twisting.
Regulator and hose
• Use only regulators and hose approved for LP Gas at the above pressures. The life
expectancy of the regulator is estimated as 2 years.
• The use of the wrong regulator or hose is unsafe. Always check that you have the
correct items before operating the barbecue.
• The hose used must conform to the relevant standard for the country of use. Worn or
damaged hose must be replaced. Ensure that the hose is not obstructed, kinked, or
in contact with any part of the barbecue other than at its connection.