Connection To A Gas Cylinder - Klarstein Parforce Duo Handbuch

EN
20

CONNECTION TO A GAS CYLINDER

After purchasing your gas cylinder you will then be ready to set it up with gas grill.
• When changing the gas cylinder which shall be carried out away from any source
of ignition. Position the gas cylinder at left side of your gas grill. It must not be
placed inside the grill. Keep in mind that the bottle must be kept away from heat
and in a safe position.
• When ready to use your gas grill insert the regulator into the gas bottle valve and
tighten firmly.
Warning
Risk of exposion. Risk of fire.
Before attempting to light your gas grill you must refer to your lighting
instructions and warning / safety points.
You will need LPG gas bottle and proper regulators under the gas pressure to operate
this gas grill. The regulators should be comply with EN12864 with current version and
national regulation.
Ensure that the hose is not subjected to twisting which will affect the gas flow when
installing your gas grill. Also the hose must not have undue tension and must not touch
any part of the gas grill which may be hot.
Please choose flexible hose whose heatproof higher than 80
Flexible tube should be changed every 2 years; It's necessary to change the flexible
tube when the national conditions require it.
How to change your cylinder
Note: Turn off the switch of cylinder (No spanner is required).
The height of the gas cylinder is below the 80 cm, and the width is within 35 cm.
1. Turn the orange cap so that the arrow is pointing to the gap in the shroud.
2. Remove the orange safety cap by pulling the lanyard out, then out. Do not use
tools. Leave the cap hanging.
3. Check that the black sealing washer is fitted inside the cylinder valve. Connect the
regulator to the valve.
4. Turn the switch clockwise on gas bottle-then turn on the gas grill as instructed.
How to disconnect a gas bottle
1. Except for twin-cylinder installations with a changeover valve, turn off the gas tap
if fitted to the appliance. Wait until the burner and pilot light have gone out. For
installations with a changeover valve, it is only necessary to switch off the empty
cylinder.
2. Replace the orange safety cap onto the empty cylinder.