Specifications - Makita 5604R Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Clamping screw
2-1. Clamping screw
3-1. Base
3-2. Cutting line
4-1. Setting protuberances
4-2. Hex socket bolt (For adjusting riving
knife)

SPECIFICATIONS

Max. cutting depth
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles in
wood while in firm contact with the workpiece.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Vibration
The vibration
determined according to EN60745:
Work mode : cutting chipboard
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Downloaded from www.Manualslib.com
Explanation of general view
4-3. Cutting depth
5-1. Switch trigger
5-2. Lock-off button
6-1. Hex wrench
6-2. Shaft lock
7-1. Hex socket head bolt
7-2. Outer flange
Model
Blade diameter
at 90°
at 45°
-1
No load speed (min )
Overall length
Net weight
Safety class
) : 93 dB(A)
pA
) : 104 dB(A)
WA
Wear ear protection
total value (tri-axial vector
2
) : 2.5 m/s or less
h
2
manuals search engine
ENE028-1
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
ENF002-1
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
ENG102-2
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
EC Declaration of Conformity
ENG214-2
We Makita
sum)
manufacturer declare that the following Makita
machine(s):
Designation of Machine: Circular Saw
Model No./ Type: 5604R
are of series production and
Conforms to the following European Directives:
98/37/EC until 28th December 2009 and then with
2006/42/EC from 29th December 2009
And are manufactured in accordance with the following
standards or standardised documents:
3
7-3. Saw blade
7-4. Inner flange
8-1. Vacuum cleaner
10-1. Rip fence (Guide rule)
11-1. Limit mark
12-1. Brush holder cap
12-2. Screwdriver
5604R
165 mm
54 mm
35 mm
5,000
320 mm
3.9 kg
/II
Corporation as the responsible
ENG901-1
ENH101-12