Connecting The Dishwasher To The Electricity; Water Hardness - hanseatic HG6085C147635RW Gebrauchsanleitung

Connecting the dishwasher to
the electricity
WARNING!
Risk of electric shock!
Faulty electrical installation or excessive
mains voltage may result in an electric
shock.
Prior to connecting the dishwasher,
■
ensure that you have page EN-5 tak-
en note of all the safety instructions
and adhered to them.
Fire hazard!
Never use multi-socket adapters,
■
multi-socket strips, travel adapters or
the like.
Depending on the location the dishwasher
must be connected before or after assembly/
installation.
– For the electrical connection of the dish-
washer, a professional must install an
earthed power socket with its own fuse of a
sufficient size (220–240 V~ / 50 Hz / 10 A).
– The plug must be installed in such a way
that the recess into which the dishwasher
will be fitted is deep enough even when the
plug is plugged in.
– Do not use a multi-socket extension cable,
multi-socket plug, travel adapter, extension
cable or similar.
– We recommend using a pulse-sensitive
residual current device (RCD).
• Connect the mains plug to a properly in-
stalled socket with an earthing contact.
Set-up, connection and initial start-up

Water hardness

Determine water hardness
In order to determine the water hardness in
your place of residence, you can
– look on the website of your water provider.
– telephone your water supplier.
– purchase suitable test strips at the
pharmacy.
Degree of
household water
hardness
0–5 °dH
6–11 °dH
12–17 °dH
18–22 °dH
23–34 °dH
35–55 °dH
1. Obtain the appropriate setting from the
table above.
2. Close the dishwasher door.
3. If the dishwasher is switched on, switch it
off with the
Page EN-33
Correct setting
H1
H2
H3
H4
H5
H6
(1) button.