Connecting The Inlet Hose - hanseatic HG6085C147635RW Gebrauchsanleitung

Page EN-32 Set-up, connection and initial start-up
You can connect the end of the outlet hose in
two different ways:
– Connection to a floor drain.
– Direct connection to the odour seal (siphon)
of your washing/dishwashing basin.
Technical measures are required for this.
For this reason, only plumbing experts or
members of our service team may con-
nect the outlet hose (see page EN-39).
The outlet hose must be a maximum of
1000 mm above the floor.

Connecting the inlet hose

NOTICE
Risk of damage!
The dishwasher is set up for a water
pressure of 0.4 bar to 10 bar (0.04 MPa
to 1.0 MPa). Water must always be
able to run freely into the dishwasher,
otherwise this can damage the
appliance.
If the water pressure is higher than this,
■
install a pressure reducer. If in doubt,
enquire about the water pressure
with the water supply company.
Ø ≥ 40 mm
Never connect the appliance to the
■
water tap or the mixing arm of a wa-
ter heater (continuous fl ow heater,
pressure-free boiler etc.).
Ensure that the inlet hose is not
■
kinked and is carefully connected.
Do not cut through the inlet hose.
■
It contains electrical components.
If the inlet hose is damaged, have it
repaired by a specialist ("Service" see
page EN-39).
Do not use old or previously installed
■
inlet hoses.
3
¾ inch
Inlet hose
For water supply, you need a water tap with
a ¾ inch screw connector.
1. Screw the safety valve's lock nut to the
tap hand-tight.
2. Check that the connection to the water
tap is sealed. Turn on the water tap slowly
and ensure that no water is escaping.
Then close the valve again.