Overheating Protection; Tilt Protection - Silvercrest SHLS 1800 A1 Bedienungsanleitung Und Sicherheitshinweise

Start the app and add your fan heater.
In order to add the fan heater in the app, you must enable the fan heater WiFi function as follows:
•
Press and hold the
•
Wait about 2 seconds, the Timer LEDs (14) (2h, 4h and 8h) flash quickly.
•
Press and hold the
•
Wait about 2 seconds, the Timer LEDs (14) (2h, 4h and 8h) now flash slowly for about 3
minutes.
•
Within these 3 minutes, the app can search for the fan heater and add it.
Now you can control the fan heater either using the app, the remote control or directly on the
device.

9.6 Overheating protection

The fan heater is fitted with overheating protection which automatically switches off the heating
element in the event of internal overheating. The fan continues running to accelerate the cooling of
the fan heater. As soon as the fan heater has cooled down again, the heating element switches
back on automatically.
FIRE HAZARD!
The overheating protection does not normally trigger for no reason. Check the following:
•
Can the fan heater emit heat without impairment?
•
Is the fan heater too close to a wall or another object?
•
Is the fan heater covered?
•
Are the air inlet grille (12) and the air outlet grille (3) on the fan heater free?
•
Is the filter (11) dirty and needs to be cleaned?
•
Is the fan blocked by a foreign body?
Confirm any obvious problems immediately or consult the manufacturer. If the overheating
protection triggers again without an obvious reason, there could be a technical fault. In
this case, stop using the fan heater and consult the manufacturer.

9.7 Tilt protection

The fan heater is fitted with a safety switch (5). This is on the base of the device. If the fan heater is
not straight or falls over, the safety switch (5) triggers automatically.
•
Place the fan heater in an upright, safe position where the safety switch (5) is pressed.
•
The fan heater does not switch back on automatically. Please select the function you want
again.
FIRE HAZARD! The safety switch (5) must not be tampered with or blocked in order to
operate the fan heater in a non-upright position.
button (16) for about 5 seconds until a beep sounds.
button (16) again for about 5 seconds until a beep sounds.
SilverCrest SHLS 1800 A1
English - 37