Copyright; Before You Start; Remote Control / Inserting The Battery; Getting Started - Silvercrest SHLS 1800 A1 Bedienungsanleitung Und Sicherheitshinweise

SilverCrest SHLS 1800 A1

7. Copyright

All the contents of this user manual are protected by copyright and provided to the reader for
information only. Copying data and information without the prior explicit written consent of the
author is strictly forbidden. This also applies to any commercial use of the contents and information.
All texts and diagrams are up-to-date as of the date of printing.

8. Before you start

Please unpack the fan heater and remove all packaging material. Inspect the fan heater for any
damage. If the fan heater is damaged, do not use it.

8.1 Remote control / inserting the battery

The remote control supplied can be stored in the remote control compartment (8) of the fan heater
when not in use. You can operate the fan heater in the same way from the control panel (2) of the
fan heater or using the remote control.
The battery has already been fitted into the remote control. Remove the plastic strip
sticking out of the battery compartment in order to activate the battery.
If the battery in the remote control is empty, replace it with a new type CR2032 3 Volt battery. The
procedure is as follows:
•
Press the closure flap on the battery holder of the remote control towards the centre (Diagram
A). Pull the battery holder out.
•
Remove the empty battery and insert a new battery. Make sure the polarity is correct (+/-).
•
Push the battery holder back into the remote control until the closure flap clicks into place.

9. Getting started

DANGER! When switched on, the temperature of exposed surfaces may be very high.
There is a risk of getting burnt!
DANGER! Always unwind all the power cable (9). There is a risk of fire.
DANGER! Keep a clearance of at least one metre to walls, furniture and other devices.
There is a risk of fire.
When you use it for the first time, smells or slight smoke may develop. This is normal and
perfectly safe. However, do make sure there is sufficient ventilation.
•
Switch the On/Off switch (10) off.
•
Plug the mains plug into an easily accessible mains socket.
You can operate the fan heater in the same way from the control panel (2) of the fan heater or
using the remote control.
34 - English