Starting Up; Fan Mode; Turning Off; Thermal Overload Protection / Safety Shut-Down - Silvercrest SKWH 2000 A2 Bedienungs- Und Sicherheitshinweise

When drilling, make sure that you do not
damage concealed power lines!
Drill two holes with a 6 mm drill and insert the
supplied wall dowels J into them.
Screw the fastening screws I into the wall do-
wels J . Each screw I shall protrude to about
10 mm.
Place the heater onto the fastening screws I
(see Figure 9).
9
Now move the heater to the right and then
down.

5. Starting up

Connect the fan heater to a grounded and secured
socket. To supply the electric current to the device,
turn the ON/OFF switch H to the "I"-position.
The device is now at the standby mode. Its display
shows the ambient temperature.
Now you can turn the fan heater ON and OFF,
as follows:

5.1 Fan Mode

To use the ceramic wall heater as a fan only,
proceed as follows:
On the control panel: In Standby mode, press
the ON/OFF button E once. The unit is now in
fan mode.
With the remote control unit: In Standby
mode, press the ON/OFF button 1 once. The
unit is now in fan mode.

5.2 Turning off

To turn the device off, please press the
ON/OFF button 1 on the remote control
unit. To disconnect the fan heater from the
power supply, set the ON/OFF switch H
to position 'O'.
Please note: If you turn the unit off, the fan will
still run 30 seconds. Then the unit will switch off.
A countdown is shown on the display (only after
heating function).
5.3 Thermal overload Protection / Safety
Shut-Down
If the measured room temperature is 51°C, the device
switches off automatically. The fan runs 30 seconds be-
fore it turns off. A countdown is shown on the display.
GB/IE/NI/CY/MT 17