To fix the handle push it into the corresponding holes (direction 1).
Now pull the handle vertically down (direction 2).
Remove the handle in reverse order, so lift the handle upwards first and then pull it off
the door.
This figure is a sketch which does not represent the real design of your handle.
An electrical supply of 220-240V AC / 50 Hz is required. Only use a suitable and
properly grounded socket near the appliance.
For your personal safety, the appliance must be grounded. The appliance is equipped
with a 3-pin grounding plug. Use a suitable socket to minimize the risk of an electric
shock.
Before you switch your appliance on, check if the voltage of your energy supplier meets
the values on the model plate.
Handle
fixing - removing
Electrical connection
54