Setting Up; Safety Information; Check Contents Of Pack; Connecting The Base Station - switel D6540 Bedienungsanleitung

3

Setting up

3.1

Safety Information

WARNING! Before setting-up, it is essential that you read the General
Information at the beginning of this manual.
3.2

Check contents of pack

The following items are supplied:
one base station
three charger with power supply
four handsets
one telephone connecting cable
3.3

Connecting the base station

Position the base station near to your telephone connection socket and to
a mains socket. Your telephone works using Touch-Tone Dialling.
1. Insert the plug of the power supply into the socket on the rear of the
base station and plug the power supply into a properly installed 230 V
mains socket. The plug-in power supply for the base station must
always be connected. For safety reasons, use only the plug-in mains
power supply provided.
2. Connect the telephone cable supplied to the telephone socket and the
telephone jack on the rear of the base station. Use only the new
telephone cable provided.
3. If required, clamp the two cables in the cable channel underneath the
foot support and then run these through the two openings towards the
rear.
Note: The two plugs must audibly click into place so that they do not fall
out again.
3.4

Connecting the charger

Set up the charger within reach of a electricity supply socket.
80
Downloaded from www.Manualslib.com
- Setting up -
manuals search engine
one mains power supply
one instruction manual
eight standard batteries