Cleaning Before Use; Commissioning The Appliance - hanseatic HGS18560DA2I Gebrauchsanleitung

Page GB-26 Start-up
(17)
3. Slide the decorative cover (17) over the
handle.

Cleaning before use

To remove the odour which is present in all
new appliances, wipe the interior with dilut-
ed vinegar prior to first use. Then wipe it out
with clean water and dry all of the parts off
afterwards.

Commissioning the appliance

WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
Do not operate or continue to oper-
■
ate the appliance if
it shows visible signs of damage,
–
e.g. the power cord is defective,
it starts smoking or there is a smell
–
of burning,
it makes unfamiliar noises.
–
Should this occur, remove the mains
plug or unscrew/isolate the fuse and
contact our service department (see
"Service" on page GB-32).
Do not connect to a timer or a sepa-
■
rate remote-controlled system for dis-
tance monitoring and control.
If the mains plug is no longer acces-
■
sible after installation, an all-pole dis-
connecting device complying with
overvoltage category III must be
connected to the house wiring with a
contact gap of at least 3 mm; this in-
cludes fuses, circuit breakers and con-
tactors.
Do not kink or pinch the mains cord
■
or lay it over sharp edges. This can re-
sult in a break in the cable.
CAUTION
Fire hazard!
Improper handling of the appliance
can lead to fi re and property damage.
Only connect the appliance to a
■
properly installed and earthed elec-
tric socket. Do not connect to a mul-
ti-socket extension cable or a mul-
ti-socket plug.
NOTICE
Risk of damage!
If the appliance has been transported
horizontally, lubricant from the com-
pressor may make its way into the cool-
ing circuit.
Allow the appliance to stand upright
■
for approx. 2 hours after transport
and before connecting. This allows
the lubricant enough time to fl ow
back into the compressor.
• Insert the mains plug into an easily acces-
sible and properly installed socket (220-
240 V~ / 50 Hz).