Installing The Door Handle; Cleaning Before Use; Electrical Connection - hanseatic HRGS8455CMBK Gebrauchsanleitung

First use
Page EN-20

Installing the door handle

NOTICE
Risk of damage!
The coating of the casing is sensitive.
When installing the door handles,
■
make sure you do not scratch the
coated surface.
(c)
1. Unscrew the countersunk screws (c) from
the door and put them safely to one side.
2. Screw the two fixing screws (d) into the
empty thread holes.
(d)
3. Place the door handle (b) on the fixing
screws (d).
4. Secure the door handle with the small
screws provided (e).

Cleaning before use

Wipe the interior with vinegar water before
2x using the appliance for the first time. Then
wipe it out with clean water and dry all of the
parts off afterwards.

Electrical connection

Risk of electric shock!
Touching live parts may result in severe
(d)
injury or death.
When positioning the appliance, en-
■
sure the supply cord is not trapped
or damaged. Do not kink the supply
cord or lay it over sharp edges.
Do not connect to a timer or a sepa-
■
rate remote-controlled system for dis-
(b)
tance monitoring and control.
Do not locate multiple portable sock-
■
et-outlets or portable power supplies
at the rear of the appliance.
(e)
WARNING
(b)