Page 8 of 20
PICTURE 27
FITTING INSTRUCTIONS
•
To fit the R&G tail tidy, first remove the pillion seat using the key as shown in
picture 1.
•
Slide the rider's seat catch as shown in picture 2 and remove the rider seat.
•
Remove the four bolts arrowed in picture 3.
•
Remove the five bolts arrowed in pictures 4 and 5, then remove the side
panel/cover as shown in picture 6.
•
Repeat the above for the opposite side.
•
Remove the four bolts arrowed in picture 7, then carefully unclip and remove the
rear seat cowl as shown in picture 8.
•
Disconnect the three wiring plug sockets for the licence plate illuminator and
indicators arrowed in picture above.
•
Carefully lower the original licence plate bracket while feeding the wiring through
the hole in the under-tray as shown in picture 9 and remove.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
R&G
www.rg-racing.com
Email:
LP0291
PICTURE 28
info@rg-racing.com