Rimage PrismPlus! Benutzerhandbuch Seite 23

Rimage PrismPlus! User Guide
4. Install the supply roller as shown. Leave some slack in the ribbon leader.
a. Press the
threaded to the front of the Prism.
b. Remove the tape from the
c. Remove the
take-up roller.
5. Load the
a. Place the
roller. It is designed to fit only one way.
b. Place the
shown.
-
Important!
c. Pull the ribbon leader up over the cardboard core and attach the adhesive strip to the cardboard core so that the
edges on the ribbon leader are aligned to the edges of the cardboard core. The arrow illustrates the wrap direction.
d. Roll the
roller.
-
Important!
STOP - Wind Leader Onto Take-up Core Stopping here.
20
Downloaded from www.Manualslib.com
operator button until the printer tray comes out. The ribbon is
printer tray.
adhesive strip from the ribbon leader.
new empty cardboard core on the take-up
take-up roller on top of the ribbon leader as
The gear must be on the correct side.
ribbon leader so that it is wrapped only once around the
Do not roll past the marking on the leader that states
manuals search engine
Supply Roller
Gear
Adhesive Strip
Cardboard Core
Ribbon Leader
110635_J