Change The Print Ribbon - Rimage PrismPlus! Benutzerhandbuch

Change the Print Ribbon

Rimage supports only the use of Rimage brand ribbons in our printers. Printer issues that occur as a result of using ribbons by
manufacturers other than Rimage are not included under your Rimage warranty or maintenance agreement.
Tip: If ribbons are stored in an environment much different from that of the printer, allow time for them to become
acclimated to the new environment. Allow more time for greater temperature and/or humidity differences.

Note : If you are replacing the ribbon, now is a good time to clean the print head. Refer to
17.
1. Access the ribbon area.
a. Power on the
b. Remove the
c. Lift up the
first, then lift the take-up roller out of the printer.
d. Lift up the
2. Load the print ribbon.
a. Slide the
b. Align the two
the supply roller.
c. Peel the
d. Slide the
3. Tape the ribbon leader to the back of the printer tray as shown.
110635_J
Downloaded from www.Manualslib.com
Prism.
top cover from the printer.
take-up roller so that the end with the gear comes up
supply roller to remove it.
print ribbon onto the supply roller.
notches of the cardboard core to the metal pins on
ribbon leader from the supply ribbon.
ribbon leader under the ribbon guide.
manuals search engine
Maintain the Prism Printer
Clean the Print Head
Take-up Roller
Print Ribbon
Cardboard Core
Metal Pins
Supply Roller
Tape Ribbon Guide
Printer Tray Ribbon Leader
on page
Supply Roller
Notches
19