Fehlerliste Can-Buskoppler Occ11C; Sdo Error Codes - SEW-Eurodrive MOVI-PLC I/O-System C Handbuch

9.3

Fehlerliste CAN-Buskoppler OCC11C

9.3.1

SDO Error Codes

Code
0x05030000 Toggle bit not alternated.
0x05040000 SDO protocol timed out.
0x05040001 Client/server command specifier not valid or unknown.
0x05040002 Invalid block size (block mode only).
0x05040003 Invalid sequence number (block mode only).
0x05040004 CRC error (block mode only).
0x05040005 Out of memory.
0x06010000 Unsupported access to an object.
0x06010001 Attempt to read a write only object.
0x06010002 Attempt to write a read only object.
0x06020000 Object does not exist in the object dictionary.
0x06040041 Object cannot be mapped to the PDO.
0x06040042 The number and length of the objects to be mapped would exceed PDO length.
0x06040043 General parameter incompatibility reason.
0x06040047 General internal incompatibility in the device.
0x06060000 Access failed due to an hardware error.
0x06070010 Data type does not match, length of service parameter does not match.
0x06070012 Data type does not match, length of service parameter too high.
0x06070013 Data type does not match, length of service parameter too low.
0x06090011 Sub-index does not exist.
0x06090030 Value range of parameter exceeded (only for write access).
0x06090031 Value of parameter written too high.
0x06090032 Value of parameter written too low.
0x06090036 Maximum value is less than minimum value.
0x08000000 General error.
0x08000020 Data cannot be transferred or stored to the application.
0x08000021 Data cannot be transferred or stored to the application because of local control.
0x08000022 Data cannot be transferred or stored to the application because of the present device
state.
0x08000023 Object directory dynamic generation fails or no object directory is
present (e.g. object directory is generated from file and generation fails because of
an file error).
Fehlerliste CAN-Buskoppler OCC11C
Error
Handbuch – MOVI-PLC
Service
9
201
®
I/O-System C