DF-models I-Peak 100 V3 Betriebsanleitung Seite 55

BATTERY MEMORY SET
TVC= YOUR R I SK
4 . 2 0 V
DEC. INC.
TEMPERATURE
CUT- OFF 5 0 C
DEC. INC.
SAVE P ROGRAM
ENTER
SAVE P ROGRAM
S AVE
Start
>3 seconds
Enter
BATT M EMORY【1】
L i Po 7 . 4 V( 2 S)
Next flash
BATT M EMORY【1】
C: 4 . 9 A D : 2 . 2 A
ENTER C HARGER
L OAD... ...
Set the terminal voltage, it can be adjusted
(4.18-4.30V)
Watch out !!! The tension must be correct for those affected,
otherwise it can lead to fire or explosion.
Set the cut-off temperature, it can be
adjusted(20 C/68 F-80 C/176 F).
Press the START/ENTER button more than 3
seconds to save the program.
This screen indicate the saved profile.
This program is to load the data stored at the
"save data" program.
Press the START/ENTER button more than 3
seconds to load a memory, otherwise, you only
enter to the setting mode.
Loading the data.
23