Charging Nimh/Nicd Battery In Re-Peak Charge Mode; Discharging Of Nimh/Nicd Battery - DF-models I-Peak 100 V3 Betriebsanleitung

NIMH/NICD BATTERY PROGRAM
Battery
Elapsed
voltage
Battery
time
Charge
type
current

CHARGING NIMH/NICD BATTERY IN RE-PEAK CHARGE MODE

Re-peak Charge Mode (NiMH and NiCD batteries only): In re-peak
charge mode, the charger can peak charge the battery once, twice or
three times in a row automatically. This is good for confirming the
battery is fully charged, and for checking how well the battery receives
fast charges. A five minute cool-off delay occurs after each re-peak
charge. Press START/ENTER button more than 3 seconds to start the
charging.
Start
Enter
Elapsed Charged
Battery
time capacity
type
Charge
current

DISCHARGING OF NIMH/NICD BATTERY

DEC. INC.
Battery
type
Batt type Start
Stop Enter
The screen displays real-time charging
status. Press BATT TYPE/STOP button to
stop the process.
The audible sound indicates the end of
Charged
capacity
process.
Re-peak cycle number 1 shows on the
display.
Press the START/ENTER button to make
- +
DEC. INC. the re-peak cycle number blink and press
INC. or DEC. button to find the desired
number of times to re-peak charge the
battery. Press the START/ENTER button to
confirm selection.
Battery
voltage
Set discharge current on the left and final
voltage on the right.
Range of the discharge current is
- +
0.1-5.0A; range of final voltage is 0.1-25.2V.
Press START/ENTER button for more than
3 seconds to start the program.
>3 seconds
20