Storage' Control Of Lithium Battery - DF-models I-Peak 100 V3 Betriebsanleitung

LITHIUM BATTERY(LiPo/LiFe/LiIon/LiHV)PROGRAM
Start
Enter
Charging Supplied
Number
time capacity
of
Charge
cells
current

'STORAGE' CONTROL OF LITHIUM BATTERY

This function is for charging/discharging batteries which are not used at
once. This program is designed for charging or discharging of batteries
of specific original state. They are classified by types: 3.7V Lilon,
3.8V LiPo, 3.3V LiFe and 3.9V LiHV. The program will begin to discharge
if the original state of battery exceeds the voltage level of storage.
- +
DEC. INC. DEC. INC.
Batt type Start
Stop Enter
If both numbers are identical you can start
charging process. If not, press BATT TYPE/
STOP button to go back to previous screen
to recheck the number of cells of the battery
pack before going ahead.
This screen shows the real-time status during
Current
charge process. Press BATT TYPE/STOP
voltage
button once to stop the charge process.
battery
At this screen, you can set up the current
and voltage of the battery pack. Charging
and discharging will make the batteries
come to the voltage level of storage state.
- +
>3 seconds
This screen displays the number of cells you
set up and the processor detects.
R=Number of cells detected by charger.
S=Number of cells set by you at the previous
screen.
If both numbers are identical you can start
charging process by press START/ENTER
button. If not, press BATT TYPE/STOP
button to go back to previous screen to
recheck the number of cells of the battery
pack before going ahead.
16