Toshiba MMY-MAP0501T8 Installations-Handbuch Seite 79

7
ADDRESS SETUP
Manual address setup from remote controller
In case to decide an address of the indoor unit prior to finish of indoor electric wiring work and unpracticed outdoor
electric wiring work (Manual setup from wired remote controller)
Arrange indoor unit in which address
is set up and the wired remote controller to 1 : 1.
(Cabling example in 2 lines)
Outdoor
Indoor
Line address
Indoor address
Group address
In the above example, under condition of
no inter-unit wire of the wired remote
controller, set the address after individual
connecting of the wired remote controller.
Group address
Individual
Center unit
Terminal unit : 0002
Operation procedure
1 2
7 8
Data
11
1
4, 7, 10
Downloaded from www.Manualslib.com
Line 1 Line 2
(Line address) → → → → →
Remote
controller
Header Follower
1 1 2 2
1
2 3 1 2
1
2 2 2 2
1
(Indoor address) → → → → →
(Group address) → → → → →
: 0000
: 0001
}
In case of group control
3 4 5 6
9 10 11
End
CODE No.
SET DATA
UNIT No.
R.C. No.
UNIT
SET CL
manuals search engine
Turn on the power.
1
Push simultaneously
for 4 seconds or more.
LCD changes to flashing.
2
Using the setup temp.
12
set to the item code.
3
Using the timer time
the line address.
(Match it with the line address on the interface P.C.
board of the header unit in the identical refrigerant line.)
4
Push button.
SET
(OK when display goes on.)
5
Using the setup temp.
13
set to the item code.
6
Using the timer time
the indoor address.
7
Push button.
SET
(OK when display goes on.)
8
Using the setup temp.
14
set to the item code.
9
Using the timer time
0000
Individual = , Header unit =
0002
Follower unit =
10
Push button.
SET
(OK when display goes on.)
11
Push button.
Setup operation finished.
(Status returns to normal stop status.)
Item code
3, 6, 9
2, 5, 8
15
+ + buttons
SET CL
/ buttons,
/ buttons, set up
/ buttons,
/ buttons, set up
/ buttons,
/ buttons, set
0001
,
.