III. ASSEMBLY
Attaching or Removing Bit
NOTE:
When attaching or removing a bit,
disconnect battery pack from tool or
place the switch in the center position
(switch lock).
This tool is equipped with a keyless drill
chuck.
1. Attachment
Insert the bit and turn the lock collar
clockwise (looking from the front) to
tighten firmly until it stops clicking.
2. Removal
Turn the lock collar counterclockwise
(looking from the front), then remove the
bit.
NOTE:
If excessive play occurs in the chuck,
secure the drill in place and
the chuck jaws by turning the lock
collar and
handed screw) with a screwdriver by
turning it counterclockwise (viewed
from the front).
EY7442_7450_7950(EU).indb 10
Downloaded from
www.Manualslib.com
Lock collar
tighten the screw (left-
manuals search engine
Attaching or Removing Bat-
tery Pack
1. To connect the battery pack:
Line up the alignment marks and attach
the battery pack.
• Slide the battery pack until it locks in-
to position.
Alignment marks
2. To remove the battery pack:
Pull the button from the front to release
the battery pack.
Button
Support handle
Place the support handle at your
favorite position and tighten the handle
securely.
open
Tighten
Loosen
Always use the support handle to
ensure operating safety.
- 10 -
2012-10-16 13:33:04