Personal Protective Equipment; Owner Responsibilities - Bosch REXROTH 3 842 558 625 Montageanleitung

10/28 Safety instructions
Transport
• Observe the transport instructions on the packaging.
Installation
• Inspect the product for transport damage.
• Route the cables and lines protected to prevent mechanical damage and
ensure that no one can trip over them.
• Before installation, depressurize and deenergize the respective system part.
• Secure against being switched back on.
• Check all seals and locks for completeness and undamaged condition.
Commissioning
• To prevent condensation, allow the product to acclimatize for a few hours
before commissioning.
• Have the product approved by a specialist electrician on the basis of national
standards and requirements.
• Only start up a product that has been completely installed.
• Do not reach into moving parts.
Operation
• Check the product for malfunctions. Make sure that only authorized
personnel are
– starting or operating the system, or interfering with its normal operation.
– Operating component or part adjusters.
• Do not reach into moving parts.
Maintenance and repair
• Make sure that access to maintenance and inspection points is free
of obstacles.
• See section "Maintenance and repair".
• Depressurize and deenergize the respective system part.
• Secure against being switched back on.
2.6

Personal protective equipment

• Wear suitable protective equipment like safety footwear, close-fi tting clothing,
hair net.
You are responsible for suitable personal protective equipment.
All component parts of the personal protective equipment must be free
of damage.
2.7

Owner responsibilities

• Before commissioning or recommissioning, ensure CE conformity.
Bosch Rexroth AG, MPS: Lifting module, 3 842 559 937/2019-07