Lifting Module Referencing; Commissioning - Bosch REXROTH 3 842 558 625 Montageanleitung

18/28

Commissioning

Fastening with T-bolts
Install the product with T-bolt and fl ange nut.
Make sure the T-bolt is in the correct position when inserting it into
the slot and tightening. The notch at the head of the bolt indicates
the orientation of the T-bolt.
1 = T-bolt insertion position in the slot.
2 = T-bolt clamping position in the slot.
1
7.5

Lifting module referencing

The lifting modules are referenced before delivery.
Perform referencing on recommissioning or in case of an
unknown condition.
See operating manual of the control unit, 3 842 559 935.
8 Commissioning
For commissioning, referencing is not required. The lifting module can be taken
into operation immediately after installation.
For recommissioning, refer to section "Lifting module referencing".
As necessary, initialize the control system on initial commissioning.
See operating manual of the control unit.
Bosch Rexroth AG, MPS: Lifting module, 3 842 559 937/2019-07
2