Flott P 30 STG PV Betriebsanleitung Seite 29

Hitting the key allows choice between the pairs of parameters (1-4) and entering the corresponding values.
The final drilling depth values must be entered absolutely...
Attention: feed rate must be > zero
The next drilling depth value must not be smaller than the precding value.
In case of any wrong value, the feed unit will not start, and the wrong value is shown in the display.
Adjust mechanical end stop on maximum drilling depth.
When using maximum feed rate to the working tool surface, position ~3mm away which is needed
to slow down.
Software module „Spanbruchzyklus" („chip breaker") (optional) in cooperation with „multi feed"
(as described unter 2.3)
the chip breaker function will only work from pair of parameter 1 to 2 and 3 to 4.
Activation of „chip breaker" cycle
(As described under 2.3)
the activation of the „chip breaker" is not shown in the display (→ →).
Entering the parameters
(as described under 2.3)
hit key until in the display „Bohrverweilzeit" (meaning „drill retention time")and „Bohrintervall"(meaning
„drilling interval") is shown (after having passed "pair of parameter no 4"). Then, enter the parameter as usual.
205289 D/GB
GB
27