Flott P 30 STG PV Betriebsanleitung Seite 24

1.2 Operating Mode "Drilling with Manual Feed"
Pole-changing switch at setting "0". Main switch to position "1". Sleeve in basic position "Top". Clamp drilling depth
stop (24) at max. drilling depth.
Select (key lights up).
Spindle speed
Use pole-changing switch to select the speed step. While the machine is running, set the spindle speed with the
adjusting lever (19).
Drilling
With the drilling depth stop (24) loose, set the drill on the workpiece and hold it with the drilling lever.
Use to set the reference point. During drilling it is now possible at any time to read a digital display of the
drilling depth attained. Proceed as described under 13.1 during drilling with fixed stop.
1.3 Operating Mode "Drilling with Programmable Feed"
Pole-changing switch at setting "0". Main switch to position "1". Sleeve in basic position "Top". Clamp the drilling
depth stop (24) at maximum drilling depth..
Select (key lights up).
Spindle speed
Use pole-changing switch to select the speed step. While the machine is running, set the spindle speed with the
adjusting lever (19).
Reference point
Use the drilling crosshairs to guide the tool to the workpiece and
zero.
Feed rate
Use and o move the flashing cursor to the digit to be changed. Use
Setpoint value for drilling depth
Use and o move the flashing cursor to the digit to be changed. Use
or
Set the reference point. Use the drilling crosshairs to guide the tool to the desired drilling depth. Press
accept the displayed "Actual value for drilling depth" into the displayed "Setpoint value for drilling depth".
205289 D/GB
GB
to set the actual value for drilling depth to
or to change the value.
or to change the value.
to
22