Flott P 30 STG PV Betriebsanleitung Seite 21

GB
13.1 Adjusting the drilling depth P30-40 ST
13.1 Adjusting the drilling depth on machines with digital depth indicator Loose drill limitor, move the drill using the
lever onto the working piece, and set digital indicator to zero. During drilling process the current drilling depth can
be seen on the display. The limitor (5) can be used as fixed backstop. Move the pinion to drilling depth and clamp
limitor (5). Now the drilling depth can be adjusted ± 3 mm using by using nut (3). One turn of this nut corresponds to
1,75 mm. The drilling depth should be checked and corrected after having made one test hole.
(pic. 5)
13.2 Adjusting drilling depth without digital depth indicator
move pinion to drilling depth, clamp limitor and drill backwards to zero. Fine adjustment as per 13.1.
Caution! When drilling with automatic feed (MV, PV) the limitor (24) (pic. 12) must be clamped, otherwise
the end switch of the clutch opens automatically.
14.0 Pinion feed
14.1. The pinion feed is made with the lever.
14.2. Pinion feed with programmable feeder PV please see additional user manual.
15.0 Adjustment of table
15.1 On machines without a rack untension the clamping lever, position the drilling table and tension the clamping
lever. Attention! Secure the table against falling.
15.2 On machines with a rack untension the clamping lever, adjust the table height by means of the hand crank and
tension the clamping lever.
15.3 Attention! Squeezing danger; before adjusting the drilling table, untighten the clamping lever. After
positioning retighten again.
16.0 Adjustment of the return spring tension
Attention! Disconnect the machine from the electrical supply.
16.1 Remove plastic-cover (1). Loosen screw (8) and tension or untension the spiral spring (3) by rotating the
tension plate (2). Tighten screw (8). (s. diagram 6) Remove left side of the hood on M5/P40 ST machines for
change of spiral spring (3).
17.0 Adjustment of the speed adjustment lever brake
Attention! Disconnect the machine from the electrical supply. Adjust screw (5).Clock – wise in order to tighten
the brake. (pic. 4)
18.0 Height adjustment of drilling head
Attention! Squeezing danger; before adjusting the drilling head, untighten the clamping lever. After positioning
retighten again.
19.0 Tool change
For the change of drills or other clamping tools a tool drift/ejector as per DIN 317 is needed. This drift is put in the
spindle slot. Release the tool with soft hammer strokes.
Attention: Do not push the spindle to its top position while the drift is inserted in the spindle slot!
For reasons of tool protection remove it by hand, otherwise the impact on the vice or table might cause a damage.
20.0 Care reference and maintenance
For cleaning each standard cleaning agent for plastic is suitable.
19
205289 D/GB