Flott P 30 STG PV Betriebsanleitung Seite 23

1. Operating Modes
1.1 Operating Mode "Setup"
Spindle speed
Actual value for drilling depth
Reference point
Use the drilling crosshairs to guide the tool to the workpiece and
zero.
Feed rate
Use and o move the flashing cursor to the digit to be changed. Use
Setpoint value for drilling depth
Use and o move the flashing cursor to the digit to be changed. Use
or
Set the reference point. Use the drilling crosshairs to guide the tool to the desired drilling depth. Press
accept the displayed "Actual value for drilling depth" into the displayed "Setpoint value for drilling depth".
Saving a set of parameters (feed rate and setpoint value for drilling depth)
Pressing and
205289 D/GB
simultaneously stores a set of parameters permanently.
GB
Feed rate
Setpoint value for drilling depth
to set the actual value for drilling depth to
or to change the value.
or to change the value.
to
21