Acd-57 Xpdr Control Con Guration - AIR Avionics AIR Control Display 57 Handbuch

air avionics

6.6 ACD-57 XPDR Control Con guration

The XPDR CONTROL section contains setup parameters for the control of a connected XPDR
system.
6.6.1 VFR Preset
Here a preset value for the VFR squawk code can be entered. This value is used when the
VFR Softkey is pressed on the XPDR page.
7000
DIGIT
Figure 6.4.: VFR softkey on the XPDR page. The squawk code entered in the VFR PRESET
parameter is set if the softkey is pushed.
To change the VFR squawk code preset, please carry out the following steps:
1. Open the menu with a long push on the inner knob pushbutton .
2. Use the inner knob to navigate to XPDR CONTROL
3. Use the outer knob to select a position/digit and the inner knob to change the
value at this position.
4. Push the inner knob pushbutton to execute your selection.
5. Push the ESC softkey to leave the menu.
ACD-57 Pilot's Manual rev. 2.1 2018/07/12
VFR-Softkey
CNCL
CURSOR
VFR MDE IDNT
XPDR SQUAWK
7000
MODE: ALT
DIGIT
VFR PRESET.
6. Systemkon guration
41