AIR Avionics AIR Control Display 57 Handbuch Seite 44

6. Systemkon guration
SAGN
7000
SAGN
118.275
Figure 6.2.: COM main page with STATION NAMES parameter set to ON on the left and to
OFF on the right. Please note that in COM only con guration, station names for
both standby and active channel are shown. In all other con gurations, only
the active channel station name is shown.
To change this con guration, please carry out the following steps:
1. Open the menu with a long push on the inner knob pushbutton .
2. Use the inner knob to navigate to COM CONTROL
3. Push the inner knob pushbutton to toggle between YES and NO.
4. Push the ESC softkey to leave the menu.
6.4.3 Knob Use
With this parameter the primary use of the inner knob and outer knob on the main
page can be selected. The inner knob pushbutton function remains una ected of this
setting (always toggles active/standby channels). The default setting for this parameter is
VOLUME.
It can be set to VOLUME in order to open the volume control page when turning the
inner knob or the outer knob . In this case softkey 2 will have the function to open the
channel selection page.
It can also be set to CHANNEL in order to open the channel selection page when turning the
inner knob or the outer knob . In this case softkey 2 will have the function to open the
volume control page.
38
CHN XPDR
118.275
WALLDORF INFO
122.550
ALT
FL222
CHN NRST HIST
WALLDORF INFO
129.970
MALSCH GLD
SAGN CHN XPDR
118.275
122.550
7000
FL222
SAGN CHN NRST
118.275
129.970
STATION NAMES.
ACD-57 Pilot's Manual rev. 2.1 2018/07/12
air avionics
ALT
HIST