Scheppach MS150-46E Original Bedienungsanleitung Seite 35

When charging battery pack
• Charge battery pack only with original battery
charger.
• Do not use battery charger to charge any other
types of batteries.
• Keep battery charger dry. Avoid exposing battery
pack to rain or wet conditions.
• To reduce risk of damage to electric plug and cord,
pull by plug rather than cord when disconnecting
charger.
• An extension cord should not be used unless abso-
lutely necessary. Use of improper extension cord
could result in a risk of fire and electric shock. If an
extension cord must be used, make sure:
1. That pins on plug of extension cord are the same
number, size, and shape as those of plug on
charger;
2. That extension cord is properly wired and in
good electrical condition; and
3. That wire size is a minimum of 16 AWG to allow
for AC ampere rating of charger.
• Do not operate charger with damaged plug or cord.
The supply cord cannot be replaced. If the cord is
damaged, the charger should be replaced imme-
diately.
• Do not operate charger if it has received a sharp
blow, been dropped, or otherwise damaged in any
way. If charger is damaged it must be replaced.
Charger is not serviceable.
• Do not disassemble charger; or attempt to service.
• To reduce risk of electric shock, unplug charger
from outlet before cleaning.
• Do not short circuit; never place any object into the
battery contacts.
• The charger is not intended for use by persons (in-
cluding children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervi-
sion or instruction concerning use of the appliance
by a person responsible for their safety.
• Children should be supervised to ensure that they
do not play with the charger.
When to charge battery pack
As Required - To check available charge, press the
Battery Fuel Gauge button (E, Fig. 25) and charge if
required. See the Battery Fuel Gauge section.
How to charge battery pack
1. Connect battery charger to electrical outlet. A
green light appears. Keep battery charger dry.
Avoid exposing battery pack to rain or wet con-
ditions.
2. Slide the battery firmly into the battery charging
bay. If the red charging light does not illuminate,
remove the battery pack and reinstall. Make sure
the battery pack is firmly seated in the battery
charging bay.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
• Red light indicates battery pack is charging nor-
mally.
• Green light indicates battery pack is fully
charged.
• No light indicates battery pack is too hot or too
cold. Let the battery pack in the charger until it
reaches its normal operating temperature
• No light indicates could be also caused from a
broken battery. Replace the battery in this case.
3. A completely discharged battery pack will fully
charge in approximately one and a half (1.5) hour.
The battery pack will stay fully charged if left on
the charger.
4. When the green light indicates that the battery
pack is fully charged, it can be removed from the
charger.
5. To check available charge, press the Battery Fuel
Gauge button (E, Fig. 25) .
6. When not in use, disconnect battery charger from
electrical outlet.
Battery fuel gauge (Fig 25)
To check available charge, press the Battery Fuel
Gauge button (E, Figure 25). The display lights (D)
will indicate the approximate amount of available
charge remaining in the battery pack.
Display Lights
Four green lights
Three green lights
Two green lights
One green light
m CAUTION!
The engine does not come with oil in it. There-
fore, ensure that you add 0,45 litres of oil before
starting it up. Use normal, multigrade oil (SAE30).
The oil level in the engine must be checked each
time before mowing.
You will also need to fill in petrol, as this is also
not supplied upon delivery.
• In order to avoid any unintentional start-ups of the
lawn mower, it comes equipped with an engine
brake (Fig. 1/ Item 3) which must be pulled back
before the engine can be started. When the engine
control lever is released it must return to its initial
position, at which point the engine automatically
switches off.
• Press the engine brake lever (3) together and give
the starter cord (17) a vigorous pull. (Fig. 14)
Attention: When you pull the starting rope the cut-
ting blade rotates even when dissolved motor brake
lever. Make sure that there are no body parts in
danger zone of cutting blade.
• When the engine is running, press the drive lever
(2) to the handle (1) in order to engage drive on the
mower.
Available Charge
70% 100%
~
40% 70%
~
10% 40%
~
Less than 10%
GB | 35