Power Supply; Batteries; Laser; Transport - Sonoro SO-220 Bedienungsanleitung

2.4 Power supply

The device is electric powered, so there is always a
risk of electric shock. Therefore pay particular atten-
tion to the following:
n Never touch the power plug with wet hands.
n When you want to pull the power plug from the
wall outlet, always pull directly on the plug itself.
Never pull on the cable. It could break.
n Ensure unobstructed access to the power outlet so
that the power plug can be pulled out immediately
in case of an emergency.
n Make sure that the power cord is not bent,
pinched or run over. Lay the power cord in such a
way that it is not a tripping hazard or within reach
of children.
n Only use the AC adapter included.
n Only use extension cords that are rated for the cur-
rent of the device.
n Keep the device away from rain and moisture and
any heat sources.
n Only operate the device if the electrical voltage
indicated on the device nameplate and the power
plug matches the voltage of your power outlet.
Incorrect voltage may destroy the device.
n To avoid a fire hazard, disconnect the device com-
pletely from the power supply when you are not
using the device for a long time. Do this by unplug-
ging the power cord from the AC outlet.

2.5 Batteries

n Remove the non-rechargeable/rechargeable bat-
teries from the battery compartment as soon as
they are empty, or if you do not intend to use the
device for a period of time.
n Do not throw the non-rechargeable/rechargeable
batteries into fire, and never expose them to high
temperatures.
n Do not attempt to recharge the non-rechargeable
batteries. Do not attempt to open or short circuit
the non-rechargeable/rechargeable batteries.
Explosion hazard!
n Fluid that leaks from the batteries when these are
used incorrectly can cause skin irritation. In case of
contact, wash off the fluid with plenty of water. If
the fluid gets into your eyes, do not rub eyes.
Instead, rinse eyes immediately for 10 minutes
with water and consult a physician immediately.
n Only use batteries of the same or an equivalent
type. Explosion hazard!
48

2.6 Laser

Fig. 1: Laser
This device is classified as a Class 1 laser device. Laser
beams can injure your eyes. So please observe the
following:
n Do not attempt to disassemble the device.
n To avoid risks: All maintenance and repair work
must only be performed by the manufacturer or its
customer service department.

2.7 Transport

n To avoid damage to the inserted medium, remove
it from the device before transporting/shipping the
device.
n Whilst driving in a vehicle, store the device so as
not to endanger its occupants.
n If you ship the device, please stow it in its original
packaging. Keep the packaging for this purpose.

2.8 Ambient conditions

Safe operation of the device is only ensured if it is
used under suitable ambient conditions. So please
observe the following:
n Protect the device against the effects of the
weather. Never use the device outdoors and never
place it where it is exposed to strong sunlight.
n Never place the device on or near heat and fire
sources such as burning candles, cooker plates,
ovens etc.
n Position the device so that sufficient air circulation
is ensured. This will prevent heat accumulating
inside the device. Always keep the device at a min-
imum distance of 10 cm from other equipment or
from walls.
n Protect the device against mechanical shocks and
place it on a firm surface.
n Protect the remote control from the weather,
humidity and high temperatures (e.g. from direct
sunlight).
n Protect the device against dripping water and
splashes. Never place a container of liquid next to
or on the device.