HITEC X4 Advanced Bedienungsanleitung Seite 18

6. Operations Steps
5. If "DISCHARGE" mode is selected: The charger will
prompt for discharging rate by fl ashing "DisCharge Rate".
Use "UP" and "DOWN" button to choose the desired
current. Press "ENTER" to make the selection.
Default discharging rate for AA battery is 1000 mA, for
AAA battery is 500 mA.
6. If "REFRESH & ANALYSE" mode is selected: The charger
will prompt for the charging rate by fl ashing "Charge Rate".
Use the "UP and DOWN" button to choose the desired
current. Press "ENTER" to make confi rmation.
7. If "BREAK-IN" mode is selected: The charger will prompt
for the battery capacity in order to calculate the charging
and discharging rate automatically "mAh" will fl ash.
Increase battery
capacity
8. If "CYCLE mode" is selected: The charger will prompt for
the charging rate and discharging rate similar to the other
modes. In addition, it will also prompt for the number of
cycle to be performed by fl ashing "No Cycle".
18
Increase
discharge rate
Then it will prompt from the discharging rate by fl ashing
"DisCharge Rate". Use the "UP" and "DOWN" button to
choose the desired current. Press "ENTER" to make the
selection.
Press "ENTER" to
start REFRESH
Use the "UP" and "DOWN" button to choose the battery
capacity. Press "ENTER" to make selection.
Decrease battery
capacity
Start BREAK-IN
Use the "UP" and "DOWN" buttons to choose the desired
cycles. Press "ENTER" to make the selection.
Decrease
discharge rate
1 Second