Setting Up Set A - ViewSonic Pro9500 Bedienungsanleitung

Setting up Set A

1.
Turn on Set A.
2.
Set the lens position to the upper limit with the VERTICAL adjuster.
NOTE
superimpose well enough to the image of Set A.
• Perform the MIRROR setting first if necessary as it may change the image
position. (Operating Guide → SETUP menu)
• HORIZONTAL adjuster is recommended to be set near the center position.
3.
Adjust the image of Set A to fit the screen with the VERTICAL adjuster,
HORIZONTAL adjuster, ZOOM ring and FOCUS ring. (User's Manual (con-
cise) → Displaying the picture)
Adjust the image position using KEYSTONE and PERFECT FIT if necessary.
(Operating Guide → EASY MENU or SETUP menu)
NOTE
image of Set B may not superimpose well enough to the image of Set A. Fine
adjusting the image position of Set B electrically does not increase its image
size. Use the ZOOM ring to adjust the image size of Set B to slightly larger
than Set A.
• KEYSTONE cannot be operated when PERFECT FIT is in use. To adjust
the image using both KEYSTONE and PERFECT FIT, adjust KEYSTONE
first.
• If you are using Simple Stack, go to 2.3 Installation of the second projector
(Set B).
4.
Display the menu with the MENU button. (Operating Guide → Using the
menu function)
5.
Use the ▲/▼/◄/► buttons to go into the following menu.
ADVANCED MENU > OPTION
> SERVICE > COMMUNICATION
> STACK
STACK menu will appear on screen. (Op-
erating Guide → OPTION menu)
(continued on next page)
ViewSonic
Downloaded from www.Manualslib.com
• If it is not set to the upper limit, the image of Set B may not
• Do not adjust ZOOM ring to the widest position, otherwise the
manuals search engine
229
Installation
Pro9500