ViewSonic Pro9500 Bedienungsanleitung Seite 205

Command Control via the Network (continued)
Communicaion Port
The following two ports are assigned for the command control.
TCP #23
TCP #9715
Configure the following items form a web browser when command control is used.
Port Settings
Network Control
Port1 (Port: 23)
Network Control
Port2 (Port: 9715)
When the authentication setting is enabled, the following settings are required.
Security Settings
Network Control
ViewSonic
Downloaded from www.Manualslib.com
Port open
Authentication
Port open
Authentication
Authentication
Password
Re-enter
Authentication
Password
manuals search engine
Click the [Enable] check box to open [Network
Control Port1 (Port: 23)] to use TCP #23.
Default setting is "Enable".
Click the [Enable] check box for the
[Authentication] setting when authentication
is required.
Default setting is "Disable".
Click the [Enable] check box to open [Network
Control Port2 (Port: 9715)] to use TCP
#9715.
Default setting is "Enable".
Click the [Enable] check box for the
[Authentication] setting when authentication
is required.
Default setting is "Enable".
Enter the desired authentication password.
This setting will be the same for [Network
Control Port1 (Port: 23)] and [Network
Control Port2 (Port: 9715)].
Default setting is blank.
200 Pro9500