Installation; Installing The First Projector (Set A); Removing Pocket Caps; Preparing Elevator Feet - ViewSonic Pro9500 Bedienungsanleitung

2.2 Installing the first projector (Set A)

Removing pocket caps

When stacking the two projectors, remove the pocket
caps on Set A.
CAUTION ► It is recommended to use a pin or
the like to remove the caps. If you are using finger,
be careful not to injure your nail and finger.
• Cap storage pockets for the pocket caps
NOTE
are inside the lens adjuster door. Be sure to keep
the caps in the storage pockets after removing the
caps from the stack pockets.
To store the cap to the pocket, place the thin end of
the cap into the pocket first, then push the other side
of the cap down firmly to the bottom of the pocket.
It is important to ensure that the caps are securely
stored to prevent children and pets from swallowing
them.

Preparing elevator feet

When stacking the two projectors, set the length of the
elevator feet to the minimum using the elevator but-
tons on Set A and B.
CAUTION ► Be careful when stacking the two
projectors, the projector on top may slide down.

Deciding installation position

Decide the position of Set A and its projection angle. (User's Manual (concise) →
Arrangement and Adjusting the projector's elevator.)
NOTE • Set the tilt angle of Set A to within 12 degrees from the level line.
• Take the followings into account when considering the installation position.
- VERTICAL adjuster should be set to the upper limit position.
- ZOOM ring should not be set to the widest position.
- HORIZONTAL adjuster is recommended to be set near the center position.
ViewSonic
Downloaded from www.Manualslib.com manuals search engine
Cap storage
228

Installation

Pocket caps
Thin end
pocket
Pro9500