Herunterladen Inhalt Inhalt Diese Seite drucken

ViewSonic Pro9500 Bedienungsanleitung Seite 229

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

1.2 Important safety instruction - For Instant Stack feature (continued)
WARNING ► When removing the pocket caps from the stack pockets, be
sure to store them securely and safely inside the lens adjuster door to prevent
children and pets from swallowing the caps. If swallowed, consult a physician
immediately.
CAUTION ► Be careful not to injure your nail and finger when removing
the pocket caps.
NOTICE ► Instant Stack is a feature that allows you to stack two projectors
or arrange them side by side easily. Depending on the installation and
surrounding environment, images projected from the two projectors may not
superimpose well enough. The images cannot superimpose well enough
especially when the screen is slanted, deformed or the surface is uneven.
• Images projected immediately after turning on the projectors are unstable due
to rising internal temperature. Wait for more than 20 minutes before starting
to adjust the superimposed images.
• The image positions may shift due to temperature change, vibration, or shock
caused by hitting the projector. Install the projectors in a stable environment
when using Instant Stack. If the image positions are shifted, readjust the
images.
• The image positions may shift over time due to the tension and the weight of
the connecting cables. Make sure not to impose any load on the projectors
when arranging the cables.
• If the volume level of the built-in speakers is too high, the two projectors may
resonate, noise may occur and the image quality may deteriorate. In this
case, check the volume setting on both projectors. Lower the volume until the
symptoms disappear or arrange the projectors side by side.
• When two projectors are connected using the RS-232C cable, the Main
projector will be able to control the Sub projector. This feature is known as
Intellectual Stack. When Intellectual Stack by means of RS-232C feature is
used, RS-232C communication cannot be used to control the projector. If you
wish to control the projectors, use the LAN connection that is connected to
any of the projectors.
• When Intellectual Stack is used, the operations or settings of some functions
are restricted. Refer to this manual for details.
ViewSonic
Downloaded from
www.Manualslib.com
manuals search engine
224
Introduction
Pro9500

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Vs13835

Inhaltsverzeichnis