SPORTSTECH KS350 Benutzerhandbuch Seite 23

Mounting on the wall:
i You will find a drilling guide template displayed in the box as an assembly aid.
These can be used to mark the required drill holes. Check if the dimensions of
the template match the ready-mounted chin-up bar! Check alignment and drilling
points thoroughly before drilling!
The pull bar is attached to the wall at the brackets provided for this purpose.
Attention! An incorrectly loaded heavy load anchor can only be ext-
Step 1
For a drilling of the two main frames, two markings on the wall are now marked with
the help of the water scale. Drilling of the holes is done with a percussive drill and an
10 mm hard metal drill / rock drill.
Step 2
Begin the drilling of the first two holes with 10 mm carbide drill at low speed and low
pressure. Then drill the two holes with a 12 mm carbide drill. Take into account that
dust is generated. If a second person is nearby, they could hold a vacuum cleaner to
the well to absorb the dust.
Step 3
After completion of the first two holes, a control check is carried out using the spirit
level. If they fit exactly, the remaining plug holes are now marked and carefully drilled
as well.
Step 4
The heavy-duty anchors are hammered into the hole without damaging their threads.
All plug holes must be drilled a little bit deeper than is the length of the heavy-duty
anchors. These holes must be vacuumed with the vacuum cleaner before driving in
the anchors.
Step 5
The pull bar is attached to the wall on the brackets provided for this purpose. The
nuts of the heavy-duty anchors are now tightened with a corresponding spanner or
ring wrench.
Optional
Thanks to the metal rings provided for this purpose, you can also attach other de-
vices, for instance a punching bag, pull ropes etc. This gives you many other possible
exercises which you can perform with this device.
racted with great effort.
23