Operating Manual TouchCenter Keypad BUS-2
Operating menu
6.7
The key "Maintenance" opens the operating
menu for displaying versions, for input of the next
maintenance date and for enabling/disabling
remote parameterization.
Use the key "Version" to open the display of the
software-versions of the central control panel and
the TouchCenter. Additionally the menu shows all
available and all used ROM- and RAM memory
values.
Use the key "
" to switch back to operating
menu "Selection".
6.8 Operating menu "Addresses"
The key "Addresses" opens the operating menu
for displaying stored address informations.
Use the key "
" to switch back to operating
menu "Selection".
6.9
Operating menu "Keypad settings"
The key "Keypad settings" opens the operating
menu for adjusting of the display contrast and the
keypad tone volume.
Move the slide control by means of the finger to
the desired value and acknowledge the selection
with the key "Apply".
Only the keypad tone volume is setted.
Adjusting of the alarm buzzer is not
possible.
Use the key "
" to switch back to operating
menu "Selection".
6.10 Operating menu "Color set"
The key "Color set" opens the operating menu for
selecting the color scheme.
There are three possibilities available: "Blue",
"Green" or "Brown". Acknowledge the selection
with the key "Apply".
Use the key "
" to switch back to operating
menu "Selection".
"Maintenance"
Maintenance
Next maintenance
00.00.00
Remote parameterization
disabled
Keypad settings..
Display contrast
Keypad tone volume
Apply
6.11
Operating menu "Clean screen"
The key "Clean screen" opens the window for
cleaning the screen.
An information text about cleaning the screen
appears. The key "Continue" disables the
screen for cleaning. In the lower part the
remaining time of disabling is displayed.
After this time the menu jumps back to operating
menu "Selection".
25
Version
Enable remote
parameterization
Cancel