Touchcenter - Basic State; Led Indicators; Buzzer Function - Honeywell TouchCenter BUS-2 Bedienungsanleitung

20
4. Touch Center - basic state
arming not possible
End
28. Jan 2008
In the basic state (without impending fault or triggered detector group), the backlighting is deactivated
and the screen is dark. In case of faults, impending switch-offs or alarm, the backlighting is activated to
achieve a better signalling effect. The operator guidance and message display appear in plain text.
After touching the screen the current time is displayed. At the top the message "arming not possible" or
"Ready for internal arming" appears. With key "End" the backlighting is deactivated again.
If there are no further entries during operation, the display switches to the basic state and the display
illumination is deactivated according to the programmed operating time. Touch the screen with a finger
to reactivate the display illumination.

4.1 LED indicators

LED red lights up:
LED red flashes:
LED green lights up:
LED green flashes:
LED yellow lights up:
LED yellow flashes:

4.2 Buzzer function

Buzzer, activated
Deactivate buzzer: Touch "Buzzer off"
17:10:24
Intrusion alarm
Tamper or hold-up alarm
Unit ready for operation
Unit not
General system fault of central control panel
Mains fault of central control panel
(freely programmable by installer)
- when switch-on delay is active
- in case of internal alarm (time limited)
- in case of tamper alarm or fault until manually stopped
- after external disarming
- when clearing (system reset), walk test on
- when touching the screen as acknowledgement signal
- with door interlock function when arming and disarming
- with reminder signal after alarm and external disarming
- in case of faults
Operating Manual TouchCenter Keypad BUS-2
Ready for internal
arming
End
ready for operation
17:10:24
28. Jan 2008