Operating Manual TouchCenter Keypad BUS-2
5. Operating without / with code
The operating unit can be programmed as follows depending on the application:
- For one zone; display with code; operation with code
- For one zone; display without code; operation with code
- For one zone; display without code; operation without code
- For several zones; display with code; operation with code
- For several zones; display without code; operation with code
- For several zones; display without code; operation without code
Depending on this programming, it is necessary to enter a code before further operation or before the
system status is displayed.
5.1 Code input
- Enter code and
- Acknowledge by touching "OK".
The operating functions are distributed over 3
different authorization levels.
The desired function can only be selected if the
corresponding authorization level (4-digit code,
5-digit code or 6-digit code) has been entered.
5.2 Overview of levels of authorization
The following overview provides information on which operating functions of the intrusion control
panels 561-MB100.10 / MB48 / HB48.10 / MB24 / HB24 may require the entry of a code according to
the programming.
Code 4-digit
- View detector groups
- Start macro
- Internal arming
The levels of authorization mentioned above are not relevant for the
561-
MB256 plus. In this control panel the individual operating functions are allocated to the
operating code with 1 to 8 digits).
Ask the installer for further information on the operating code (number of digits and
released functions).
Code 5-digit
- Clear detector groups
- Internal disable detector groups
- Activate walk test
- View event memory
- Internal disarming
Operation code
Please enter code
----------
Code 6-digit
- External disabling/enabling
- Clear tamper detector groups
- Change date and time
- Panel settings
1
1
1
1
1
1
2
3
1
6
5
4
8
7
9
0
CLR
OK
intrusion control panel
21