Safety Notes; General - Honeywell TouchCenter BUS-2 Bedienungsanleitung

18

1. Safety notes

Read this manual carefully and completely before installing and starting up the device. It contains
important instructions on installation and operation.
The device is designed to state-of-the-art technological standards. It should only be used:
- correctly and
- in a technically perfect and correctly installed condition
- in accordance with the technical data.
The manufacturer is not liable for damage resulting from incorrect use.
Installation, programming, maintenance and repair work should only be carried out by authorised
skilled personnel.
Soldering, connection and installation work within the overall system should only be realised in a
deenergised condition. Soldering work should only be realised with a soldering iron with temperature
control which is galvanically isolated from the mains power supply.
German electrical standards and regulations of local electricity suppliers should be observed.
The Operating and Display Panel should not be used in rooms where there is a risk
of explosion or where vapours may decompose metal or plastic materials.

2. General

By deciding to install an intrusion detection control unit, you have taken a step towards greater security.
In the control unit unites are the most up-to-date electronics, innovative technology and years of
experience of one of the largest manufacturers of intrusion detection systems in one highly-developed
product.
The large number of operating options and alarm types and the extensive programming options
guarantee ideal adaptation to your individual security requirements.
If the control unit is also fitted with an integrated telephone dialling device, a silent alarm can be
transmitted via the public telephone network to the digitized receiving control unit of a commissioned
security firm. The security firm can then take the necessary steps (e.g. police operation). There is also
the possibility of triggering a local alarm, if the relevant person cannot be reached.
If your control unit is installed for remote parameterization, the installer can access the intrusion
detection control unit via remote programming (e.g. to change a telephone number).
These instructions explain how to work with the control unit at user level. You will learn all you need to
know about operating the device, from the functions of the display and operating elements to simple
troubleshooting.
Programming which affects the system is reserved for the installer. Please contact the installation
company if you have any problems, desires to upgrade the system, etc.
Very few operating procedures are required in normal, everyday operation. This means that
knowledge of operating and general handling can be quickly forgotten under certain circumstances.
These instructions should therefore, be stored in the immediate vicinity of the device so that they are at
hand when required.
Operating Manual TouchCenter Keypad BUS-2