Description Of Function Arming/Disarming; Intrusion Detection Control Unit Arming/Disarming; Absence Security - Honeywell TouchCenter BUS-2 Bedienungsanleitung

26

7. Description of function arming/disarming

7.1 Intrusion detection control unit arming/disarming

Arming/disarming - these terms mean practically the same thing as switching the system on and off.
To switch on means to arm the system. This can either be the "internally armed" status for presence
security or the "externally armed" status for absence security.
To switch off means to disarm the system.
Arming and disarming is performed using appropriate operating elements.
Depending on the version and components of your system, these elements can be operating units, a
block lock, a security operating panel, a door code or a proximity operating device (IDENT-KEY
System).

7.2 Absence security

Absence security refers to external arming using a
suitable operating element e.g. a block lock. This
means that you assume that the zone to be secured
has been vacated and cannot be entered even
accidentally through an unlocked door, for example.
The control unit can only be externally armed if there
is no fault in the mains or the accumulator. In addition,
no detector group or lock group may be actuated.
Also, no uncleared alarm or fault of the telefone
dialing device (transmission device) should be
pending.
Detector groups which were internally disabled are
automatically reactivated by external arming.
However, after disarming disabling is active again.
Arming is acknowledged by an audible signal which
lasts approx. 3 seconds.
Every impending alarm criterion now releases a main alarm. Depending on the system configuration,
the alarm is transmitted visually (flashing lamp) and/or audibly (loudspeaker). This alarm can also be
reported to a security service via a transmission device, if installed.
Absence security status can only be lifted by disarming using an operating element such as the block
lock. After disarming, an actuated alarm is displayed on the corresponding displays of the operating
units and on any parallel display boards installed.
The intrusion control panel 561-
of a zone by means of the operating and display panel. For this purpose the function must be
released by the installer.
Operating Manual TouchCenter Keypad BUS-2
MB256 plus additionally offers the function external arming