Automatic Address Allocation With Transponder; Manual Address Allocation Via Operating Unit Keypad - Honeywell IDENT-KEY 3 Montage, Anschluss, Anleitung

Mounting and Connection Instructions IK3 Operating Unit with Keypad
6.2.5

Automatic address allocation with transponder

The address allocation mode must be activated (see 6.2.2).
Hold an IK2 / IK3 transponder e.g. chipcard or key fob) in the reading range The operating unit
now transmits the unique number (serial number) to the EU. The EU allocates a free address to
this number and transmits the unique number plus the address back to the operating unit. After a
brief interval, the operating unit stores the address
Address acknowledgement: After approx. 1 sec. the LEDs indicate the allocated address (see
6.2.3).
EU
allocates a free
address to the
unique number
6.2.6

Manual address allocation via operating unit keypad

The address allocation mode must be activated (see 6.2.2).
When using this allocation mode, a specific address can be allocated to an
operating unit on site. The plausibility check in the EU prevents an address
from being allocated more than once.
Note:
- Every activated key is acknowledged by a click.
- An address entry can be rejected by an .
Enter the new address with 1 or 2 digits and acknowledge with OK (key
The address is transmitted to the EU and checked.
Positive acknowledgement
After remaining blank for approx. 1 sec. the LEDs indicate the newly
allocated address (see 6.2.3).
Negative acknowledgement
If the address is already occupied, it is not allocated to the operating unit and there is no address
displayed.
Change address
Enter new address with 1 or 2 digits and acknowledge with OK. (Acknowledgement and display as
described above). All allocated parameters are transmitted from the old address to the new one so
that the old address can be re-allocated.
(
Unique number
Unique number
+ address
X
permanently .
F I
1 2 3
4 5 6
7 8 9
3
r
0
.
or other
transponder
1 2
4 5
7 8
r
0
3
).
Delete Confirmation
Reject OK
23
3
6
9
3