Label Design Requirements; Print Requirements - Rimage 2000i Benutzerhandbuch

Rimage 2000i™ User Guide

Label Design Requirements

The Rimage 2000i Software includes a label editor called CD Designer™, which is installed on your PC during a typical
installation of the Rimage 2000i Software. You can use CD Designer to design your labels.
If you prefer to design labels in a software application other than CD Designer, use the following criteria:
•
File format: For best results, save your labels as JPEG or TIFF files. However, these file formats must be converted
before printing. If you use CD Designer to print labels, you must import the labels and save them as CD Designer files
(.btw) before printing. If you do not use CD Designer to print labels, you must convert the labels to PDF files before
printing.
•
Color mode: Labels iimported into CD Designer must be in RGB color mode.
•
Resolution (pixels per inch): For best results, use images set to a minimum of 300 pixels per inch.
•
Label design size: Design labels with a height of 12 cm and a width of 12 cm. A full-size disc is 120 mm (4.723") in
diameter. The hole is 15 mm (0.59"). The printable area and hub sizes may vary between disc manufacturers.

Note: The media in Rimage Media Kits have a printable area of 118 to 24 mm. On most labels, print settings of 118 mm
and 24 mm are recommended. Refer to the image below.

Print Requirements

All labels created and saved through CD Designer are in the correct file format (.btw) for printing with the Rimage 2000i. If
you are creating and saving labels with a software application other than CD Designer, save your labels as PDF files before
printing with the Rimage 2000i.
10
Downloaded from www.Manualslib.com
Printable Area
118 mm
manuals search engine
Hub Size
24 mm
100763_M