Frost Precautions; Troubleshooting - Electrolux WASL5T300 Benutzerinformation

30 www.electrolux.com
15.10 Cleaning the inlet hose and the valve filter
1.
1
2
3.
15.11 Emergency drain
Because of a malfunction, the appliance
cannot drain the water.
If this occurs, do steps (1) through (5) of
'Cleaning the drain filter'. If necessary,
clean the pump.

15.12 Frost precautions

If the appliance is installed in an area
where the temperature can be less than
0° C, remove the remaining water from
the inlet hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.

16. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
3
2.
4.
3. Put the two ends of the inlet hose in
a container and let the water flow out
of the hose.
4. Empty the drain pump. Refer to the
emergency drain procedure.
5. When the drain pump is empty,
install the inlet hose again.
WARNING!
Make sure that the
temperature is higher than
0 °C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.
O O
90 90